South Carolina's online surf shop!
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
5' 10" JS Matrix
$299.00

5' 10" JS Matrix

Description: According to the guys over at JS industries, the JS Matrix sits in between the Pier Pony (Which they no longer make, it’s been replaced by the Show Pony) and the Rock N Roll.

It’s designed for the smaller end of the wave spectrum.  The board has low entry rocker and pretty much flat tail rocker.  The result is more speed on take off and a lot more drive.

The latest JS Matrix model has reduced some of the volume in the rail over previous models allowing you to get more rail in the water when turning at speed.  The JS Matrix generates a lot of lift and speed from the underside concave design.

It starts at the nose with a single concave that changes to a double concave under the front foot, continuing the double concave right through to the fins. The single concave channels the water under the front foot generating speed and lift and double concave moves that water out the back on both sides for maneuverability and control.

- Surfing-review.com

Ride MATRIX 5-6 inches smaller than normal with either quad, thruster or 2.1 with stabilizer fins.

Shaper: JS Industries out of Australia
Wave height: Ideal for around 1ft to 3ft waves
Fin boxes: 5 FCS fin boxes
Comes with: 

  • Dakine traction pad (great condition)
  • FCS fins (thruster setup)

Dimensions: 5’ 10”x 21”x  2 3/4” 34.8L
Condition: The board is in very good condition. It has one very minor repair near the nose. The repair was professionally done, guaranteed for craftsmanship for the life of the board, and the board is completely water tight. The board has some pressure dings which is normal for a used board.